Boss RC30 with Rane TTM56 Mixer

[Sygboe]

Hi I saw an old thread on loopers land hoped you could help me.

 

I have a rane ttm56 and a boss Rc30.

I can't work out the best way to wire it up while using the fx send function.

Rather than only recording the sounds from the decks it's also recording the output of the looper over itself.

Any advice would be good. Also I want to try and add reverb and delay (with some device I will buy) would this have to be chained in somehow?

 

Any help appreciated

Stu

[Jam Burglar]

You must have it wired in a loop or something (maybe you're running your master out into the looper instead of your effects send)?.

 

Run 1/4" cables from the effects send jacks on the 56 to the looper input, then run 1/4" cables from the looper output to the effects return on your 56. Put the effects on your looper all the way to 100% wet (all the way to the left). Turn on your effects for the channel you want to route through the effects loop (left deck, righ deck, or both). You should be good to go.

 

If you want to add reverb and delay, put those in the chain before the looper.